↓ Skip to Main Content
Moto East Tuning & Performance. MX5, Subaru BRZ/FR-S, Nissan G37/370Z/GTR, BMW N55/B58, Subaru WRX/STI/FXT Tuning.

Main Navigation

  • Home
  • RSS Feed
Home › Archive for FT86

Category: FT86

Sprintex BRZ/FR-S Pulley Selection Chart

By motoadmin Posted on September 4, 2015 Posted in FT86, Tech No Comments

We get this question almost daily! What pulley to run on 91 octane? What about intercooled? Can the 335 system be used on a road course? The worksheet below summarizes our experience running every version of the kit. The limitations of …

Sprintex BRZ/FR-S Pulley Selection Chart Read more »

Tagged with: 210, 335, boost, built motor, chart, pulley, sprintex

Initial Sprintex 335 Dyno Testing

By motoadmin Posted on December 16, 2014 Posted in FT86, Products, Tech No Comments

We made some progress today, and caught a quick break to get on the dyno. Bear in mind our goal was to see if this could do double duty as a reasonable mid range system with upgrade potential, vs a maxxed …

Initial Sprintex 335 Dyno Testing Read more »

Tagged with: brz, dyno, ecutek, gt86, racerom, sprintex, sprintex 335, subaru, supercharger

Sprintex 335 Installed & Tuned!

By motoadmin Posted on December 12, 2014 Posted in Builds, FT86, News, Products, Tech No Comments

It is in! Here are some installed photos with our 3″ intake, and make sure to check out the YouTube link as well: https://www.youtube.com/watch?v=7GY-X11e_nM    

Tagged with: sprintex, sprintex 335, video

Sprintex 335 BRZ/FR-S Systems are Here!

By motoadmin Posted on December 3, 2014 Posted in Builds, FT86 No Comments

  This begins a new chapter for the Moto-BRZ. We’re adding an ACT XT unit to handle the torque, and we will see how far the stock motor will go with this unit!  

Tagged with: brz, fr-s, sprintex, sprintex 335

JDL BRZ/FR-S Turbo Kit Results!

By motoadmin Posted on October 29, 2014 Posted in FT86, Products No Comments
JDL BRZ/FR-S Turbo Kit Results!

We spent a few hours working with a customer on a JDL kit. First order of business is to see how our remote tune stacked up. We did the baseline run, then spent about an hour trying some additional variations …

JDL BRZ/FR-S Turbo Kit Results! Read more »

Tagged with: #mototuned, failsafe, jdl, overboost, turbo

Skunk2 BRZ Intake Tested!

By motoadmin Posted on October 18, 2014 Posted in FT86, Products No Comments

A customer wanted to get every last HP out of a car, and we of course are more than happy to do what it takes. While some of the intakes have a large MAF housing, they require pinching of the …

Skunk2 BRZ Intake Tested! Read more »

Tagged with: brz, intake, skunk2

Kraftwerks BRZ/FR-S C38 Dyno Results!

By motoadmin Posted on October 17, 2014 Posted in FT86 No Comments

The guys over at Hux Racing in Alabama installed and dyno’d a kit this week, and here are the results, over 300 on pump gas! This is all achieved on stock fueling and the stock pulley. Not only that, but …

Kraftwerks BRZ/FR-S C38 Dyno Results! Read more »

Overboost Protection – It Works!

By motoadmin Posted on October 13, 2014 Posted in FT86, Tech No Comments

What happens when a misrouted wastegate is employed? Normally fireworks and rods exiting the vehicle. However in our example here, the motor was saved. You can see a few things here. First off the timing goes way negative, and engine …

Overboost Protection – It Works! Read more »

Tagged with: brz, ecutek, overboost

Kraftwerks BRZ/FR-S Dyno Results

By motoadmin Posted on June 14, 2014 Posted in FT86, News, Products, Tech No Comments

Having done several of these cars, we had a chance to get an otherwise 100% stock car with the Kraftwerks base kit on there. With 100% humidity and warm weather (and a broken weather station on the dyno so no …

Kraftwerks BRZ/FR-S Dyno Results Read more »

Innovate Intercooled Results

By motoadmin Posted on March 13, 2014 Posted in FT86, News, Tech 2 Comments

  Highly anticipated, this kit is now available with the intercooled option. Initially there was a great deal of trouble sorting the power above 5,000 RPM, but as it turned out, there is an incompatibility with the aftermarket MAP sensors …

Innovate Intercooled Results Read more »

Tagged with: 3 bar, 4 bar, innovate, intercooler, map sensor, s210, sprintex

Posts pagination

1 2 Next

Search the Site

Login/Comment

  • Log in
  • Entries feed
  • Comments feed
  • WordPress.org

Getting Around

  • News
  • Tuning Myths and Facts
  • Dyno Sheets
  • Service
    • ECU Tuning & Dyno
  • Support
  • Dealers
  • About
  • Contact

Footer Menu

  • News
  • Tuning Myths and Facts
  • Dyno Sheets
  • Service
  • Support
  • Dealers
  • About
  • Contact
© 2025 Moto East Tuning & Performance. MX5, Subaru BRZ/FR-S, Nissan G37/370Z/GTR, BMW N55/B58, Subaru WRX/STI/FXT Tuning. | Powered by Responsive Theme