Starting labor rates are as follows (some excluding fluids\/consumables\/rusted components\/parts). If you are quoted anything differently, you must bring with you the written\/emailed quote, or send a followup email after a phone call. These are ESTIMATES and are only bound to be the minimum charged. Since every car is different with its own unique challenges, a simple header install can be double or more if the head studs are seized etc…. While our prices are higher than your typical neighborhood auto shop, we are committed to ensuring you get your money’s worth. We generally quote in hours, and keep in mind we may work much faster than a shop not familiar with what we do.<\/p>\n
All Vehicles:<\/strong><\/p>\n General Labor: $120\/hr<\/p>\n Fabrication (welding\/machining\/roll cages): $140\/hr<\/p>\n Custom Dyno Tuning: $220\/hr. Dyno time is billed from setup to removing the vehicle. Base tune cost is not included.<\/p>\n Oil Change: $55-95 (we use only OEM fluids\/filters)<\/p>\n Tire Mounting\/Balance: $60\/$80\/$120 (steel regular\/up to 17″\/over 17″ or difficult stretch)<\/p>\n Fender rolling\/pulling: $50\/$80 each corner<\/p>\n Wheel alignments, ride height adjustments: $120\/hour<\/p>\n Clutch\/Flywheel swap: $300-500<\/p>\n Brake pads: $90. Lines & rotors also: $200<\/p>\n Bleed & flush brake fluid: $100<\/p>\n Advanced diagnostics: $120\/hr<\/p>\n Track inspection: FREE!<\/p>\n MX-5:<\/strong><\/p>\n Rotrex SC Install: $700-1200<\/p>\n Turbo Kit Install: $1200-1500<\/p>\n Shocks\/Springs: $300-500<\/p>\n Header: $300<\/p>\n Exhaust (header back): $80<\/p>\n Intake install: $120<\/p>\n Clutch: $300<\/p>\n 2.0 Motor R&R: $1200<\/p>\n 2.5 Motor Swap: $1500<\/p>\n BRZ\/FR-S\/Subaru:<\/strong><\/p>\n Harrop\/Edelbrock\/Sprintex SC: $800 non-intercooled\/1200 Intercooled<\/p>\n Vortech SC Install: $1100<\/p>\n Rotrex\/JR SC: $1000<\/p>\n Turbo Kit: $1000-1600<\/p>\n Exhaust $120 (overpipe back)<\/p>\n Header: $220 BRZ\/350 WRX\/ 300 LGT<\/p>\n Header & Exhaust: 300<\/p>\n Intake install: $150<\/p>\n Motor Mounts: $150<\/p>\n Clutch: $300<\/p>\n We service ALL modern imports and many domestics. While the list above is for the platforms we see most often, we can take care of your BMW, Nissan, Mini, and Porsche with the same great care and reliability.\u00a0<\/strong><\/p>\n Note these are starting prices on just some of the things we do, and are subject to change at any time. Additional aftermarket components, corroded components, or other issues may add to the cost and are billed hourly. Install prices of turbo & SC kits are assumed to be bought from Moto East. Used kits or kits purchased through third parties are subject to additional charges. Sales tax is not included. We also service other imports and modern domestics.<\/p>\n About our facility: Located in Easton, PA, Moto East is your\u00a0premier\u00a0performance shop in the Lehigh Valley. Conveniently\u00a0located in the third largest metro are in Pennsylvania (Allentown\/Bethlehem\/Easton) and within 75 minutes of Philadelphia, NYC, and most of New Jersey. Offering full service, ECU tuning, and fabrication for modern imports.\u00a0<\/em><\/p>\n","protected":false},"excerpt":{"rendered":" Starting labor rates are as follows (some excluding fluids\/consumables\/rusted components\/parts). If you are quoted anything differently, you must bring with you the written\/emailed quote, or send a followup email after a phone call. These are ESTIMATES and are only bound …<\/p>\n